ButtonWorx™ Button Repair Kit 
SynScan v4 

Do-It-Yourself

• Permanent Repair
• No paint ink or glue
• Will not chip or flake off
• Tested over 1 Million button presses!
• Blocks dirt and oils forever

Permanently repairs rubber keypad buttons by replacing the conductive material.

Your buttons fails when the conductive pad wears out and silicone oils seep from the keypad. This gooey paste blocks electrical conductivity and stops the switch from working.
The ButtonWorx membrane keypad blocks dirt and oil from reaching the circuit board and offers a new conductor that cannot break down like rubber conductors do. 

Note: This is for repairing hard to press buttons. If all your buttons stopped working one day, then the remote is broken (not the buttons) and needs repair 

Our membrane keypads are custom cut for each model.

They will not work in any other model.

Please make sure you are ordering the correct part.

This is what it looks like when you remove the back cover

IMPORTANT: Clean the button contacts with Isopropyl alcohol and q-tips. 

This shows the ButtonWorx™ membrane installed over the buttons

Install the membrane as flat as possible. Just lay it over the PCB after lining up the holes and leave it alone. DO NOT press down to "stick it better" That is not necessary and you can create problems with buttons caving in which could make them activate without pressing them first.